Skip to content
ProjectControls.com
Primavera Project Planner - P3

Logo on Layouts

In the Open Standard
Mark GriffinMember for 25 years
Created
10
1
0
Has anyone experience problems printing layouts with company logo on them. If so have you been able to lay your finger on why it only prints on some layouts and not all of them. Has it been none predicable?

P3 claim there is nothing wrong with the software. But we cannot get it to print, whether it is adobe or direct to a printer, local or network.
Save Follow Follow forum Report
Reply New topic

10 replies

Oldest first
  1. 0
    Anil Gupta ·
    #1
    It does print logo’s .May someproblem with printing harware.Like less memory or so.
    Report
  2. 0
    Shahzad Munawar ·
    #2
    LOGO is printed in P3 without any problem if it is properly pasted from image file and also your printer set up is correlate with the Printer
    Report
  3. 0
    Forum Guest ·
    #3
    We are using P3 Ver 3.1 with Windows XP. We have the latest service pack installed. We have tried different logo’s and different printers.
    Report
  4. 0
    Mk Tse ·
    #4
    My experience: -
    - If the logo file size is big, fail to print
    - The printer driver support the logo format or not, same printer may have standard driver, postscript drive, PCL driver. All have different result
    - Location of logo file. Long path is not recommended.
    Report
  5. 0
    Mark Griffin ·
    #5
    I have tried different logo’s with different size files and still no luck. The path is C:p3win so very short.

    I have just seen a copy within the company that does not even allow you to attach a BMP file. It comes up with File format unknown. Any Ideas
    Report
  6. 0
    Ronald Winter ·
    #6
    You mean that the path is "C:\P3WIN" do you not? The difference between your answer and this one may be the answer to your problem.
    Report
  7. 0
    Mark Griffin ·
    #7
    Yes i did mean C:P3win Just a typing error. Any ideas now then?
    Report
  8. 0
    Ahmed Hamada ·
    #8
    hi Mark,
    try to make new layout without (Layout - Transfer), then try t oinsert the logo, i think it will work. if not, convert the logo from BMP to PMT this is a guaranteed method

    regards,
    Ahmed
    Report
  9. 0
    Ali Hamouda ·
    #9
    Hi All,,

    I have met this problem in the past..I found this problem comes from big file size..once I convert the file to Jpg formate or gif..with smaller size.(you can adjust the size through Adobe photoshop or Illustrator)..it works.

    If the Printer Memory is supporting the big file size..it will print..it depends upon the memory of the printer mainly.

    Ali Hamouda
    ===========================================================
    Report
  10. 0
    Mk Tse ·
    #10
    I have do some tests before. Same logo in different format, so different file size. Then same printer driver, some work, some not (even in preview). In most situation, due to the size of logo file is too big. I check the print queue size also, not only just print out or not). Some successful print out but the logo from colour to B/W only.

    Then select those successful logo file with different printer driver to same printer, do the test again. Some printing failure. Those printer drivers are standard, postscript and PCL.
    Report

Log in or join to reply

ProjectControls.com is free to join. Members can post questions, reply, vote and follow discussions.

Log inJoin free

Existing members: your original username and password still work. Forgot password?